Skip to main content
grasp.study
About
Explore
Pricing
Log in
Try it for free
Back to course
👋
Welcome to a Grasp lesson
Create a free account
to keep studying and create your own study path.
Deepening Professional Expertise
·
Module 2
Polymer Selection and Injection-Molding Design Science
1
Comparing Automotive Thermoplastics: Performance, Cost, and Appearance
Compare automotive thermoplastics using stiffness, impact performance, service temperature, moisture sensitivity, shrinkage, chemical resistance, dielectric behavior where relevant, mass, cost, and appearance data.
2
Polymer Selection Using a Weighted Decision Matrix
Select a polymer with a weighted decision matrix tied to component requirements and manufacturing risks.
3
Estimating Injection-Molding Cooling Time Using a 1D Heat-Transfer Model
Estimate injection-molding cooling time using a one-dimensional heat-transfer model and stated thermal assumptions.
4
Calculating Required Mold Clamp Force
Calculate required mold clamp force from projected area, cavity pressure, cavity count, and a safety margin.
5
Nominal Wall Thickness Selection and 3:1 Transition Design
Select nominal wall thicknesses and design gradual wall transitions using a 3:1 transition guideline.
6
DFM Sizing of Ribs, Gussets, Bosses, and Inserts
Size ribs, gussets, screw bosses, and insert features using DFM rules, including a rib-to-wall ratio no greater than 0.5 where visible-surface sink governs.
7
Determining Minimum Draft Angles for Molded Parts
Determine minimum draft angles from pull direction, draw depth, surface texture, and polymer shrinkage.
8
Diagnosing Injection Molding Defects from Design and Process Conditions
Diagnose likely sink, weld-line, short-shot, air-trap, shrinkage, and warpage defects from part geometry, gate strategy, and process conditions.
Previous module
Amazon EDV Program Setup, Standards, PLM, and Design Reviews
Next module
CAD Architecture, CAE Reasoning, Mold Flow, and GD&T Foundations